Unclogging a double kitchen sink with standing water can be a challenge, but there are several solutions available. You can use a drain snake, baking soda, and white vinegar, or a wire coat hanger.
Baking soda and white vinegar
There are a lot of ways to clear a clogged drain, and one of them is using baking soda and white vinegar. While these two items can make cleaning your drain a whole lot easier, it’s important to know when to use them.
Baking soda and vinegar are highly caustic and can hurt your pipes, so they are only recommended for clogged pipes that are fairly shallow. If you have a really big clog, you may need to use other methods.
The best way to get rid of a clogged drain is to use a plunger, which is a flat, wooden tool with good suction. This means that you don’t have to lift anything out of your drain to clean it.
You can also use a plumbing snake to get a clog out. However, you should not try to suck anything out of the drain with the snake. It’s best to take a little extra care when doing this, and you should definitely remove all of your soaking dishes and utensils first.
A better option is to clean your drain with a combination of salt and baking soda. When mixed, this solution is very effective in breaking up clogs.
Pouring hot water into a clogged drain can help loosen a clog and flush it out. Boiled water can also help clear a clogged drain.
Wire coat hanger
If your double kitchen sink has standing water, you may want to try a wire coat hanger to unclog the drain. Wire coat hangers are long and flexible tools that can be used to reach deep clogs. However, they must be used with care. They should not be used with chemicals, as they can damage pipes. Using a plunger is another option.
First, pour some baking soda down the drain. Then, run hot water. This will loosen any clog. Afterwards, rinse the drain with vinegar. You can also use a vacuum hose to create a tight seal around the clog.
When you are finished, you should remove the stopper from the clogged drain. Once that is done, you can reattach the p-trap. Don’t forget to wear rubber gloves when doing this.
If the clog is deeper, you may need to use a plumbing snake. Alternatively, you can make your own. A wire coat hanger can also be used as a plumbing snake substitute.
Make sure the wire coat hanger is a flexible one. It should be able to bend to fit into your drain’s fittings. Be careful not to push the clog too far down the pipe. To get the hanger down, lower it into the drain with rubber gloves. Next, twist the wire to make a hook. Push the hook down the drain to grab the clog.
Drain snake
If you have a clogged kitchen sink, you may want to try using a drain snake. A drain snake is a flexible drilling tool that can be used to unclog the drain.
This tool can be purchased or rented. It is ideal for unclogging a sink, but may not be able to handle a clog that has been left behind by a garbage disposal.
You can also use a wire coat hanger to unclog a sink. While a coat hanger will not be able to reach deep clogs, it can reach many of them.
Another way to clear your drain is to use a plunger. Plungers can be bought at most hardware stores. To use a plunger, you’ll need to find the hole in the drain. Then you’ll need to put the plunger over the hole and submerge it in water.
Once the plunger is in place, you’ll want to pump it up and down several times. Make sure you don’t push the plunger too hard. If you do, you might push a clog down the pipe.
Some people have found success in using a mixture of hot salty water and vinegar. These two ingredients are excellent unclogging agents. They will dissolve clogs and remove grease and fat from the pipe. However, it’s best to let the mixture sit for a few hours before you begin to work on the clog.
Photo by Memento Media on Unsplash
